Vinyl
Heat Transfer Vinyl
Solid
- Cut
- Mirror your design
- Place the vinyl on your cutting mat with the shiny side down
- Follow your machine's recommended blade settings:
-
Press
-
314℉ for 14 seconds, peel warm
Glitter
- Cut
- Mirror your design
- Place the vinyl on your cutting mat with the shiny side down
- Follow your machine's recommended blade settings:
- Press
- 314℉ for 14 seconds, peel warm
Foil
- Cut
- Mirror your design
- Place the vinyl on your cutting mat with the shiny side down
- Follow your machine's recommended blade settings:
- Press
- 314℉ for 14 seconds, peel cold
Patterned
- Cut
- Press
Metallic & Holographic
- Cut
- Mirror your design
- Place the vinyl on your cutting mat with the shiny side down
- Follow your machine's recommended blade settings:
- CGC Suggestions:
- Cut deep
- Perform a test cut before cutting your finished project.
- Press
- 314℉ for 14 seconds, cold peel
Puff
- Cut
- Mirror your design
- Place the vinyl on your cutting mat with the shiny side down
- Follow your machine's recommended blade settings:
- Press
- 265℉ for 10 seconds
Adhesive Vinyl
Solid
- Cut
- Place the vinyl on your cutting mat with the shiny side up
- Follow your machine's recommended blade settings:
- Application
Glitter
- Cut
- Place the vinyl on your cutting mat with the shiny side up
- Follow your machine's recommended blade settings:
- Application
Design Transfers
DTF Transfers
DTF stands for Direct to Film, a new technology that digitally prints designs using special, water-based inks, and an adhesive coating onto a polyester film.
- Press
- A commercial grade heat press is highly recommended to achieve proper adhesion.
- Temperature: 300°F - 325°F
- Pressure: HIGH
- Press Time: 10 - 15 seconds
- Peel: Warm or cold (NOT HOT)
- Re-Press with a teflon sheet or parchment paper for an additional 20 seconds.
Sublimation Transfers
- Suggested Fabric
- Material must be at least 65% Polyester
- Press
- IMPORTANT: Place a piece of butcher or parchment paper between your machine and the design. This is to protect your machine.
- 400℉ for 40 seconds